Laser Engraver Honeycomb Bed Standoff - Back Flash Reducer - Magnetic Base - 3mm and 6mm

Laser cutting on a honeycomb bed can create nasty flash back resulting in the need to sand and clean up your cuts which sometimes does not fix it. This problem is easily solved by simply lifting your material off the honeycomb.

The standoff risers are designed to elevate your material off the honeycomb bed to reduce flashback from the laser beam bouncing back during cutting, this will gave a much cleaner finish and reduce the likelihood of defects being caused which is sometimes seen with acrylics and wood. These standoff risers also have a recess on the bottom and contain a small magnet for better security during cutting. Due to its design of using magnets to hold the riser in place, this is suitable for all sized honeycombs.

The riser is dual use and designed to hold 3mm and 6mm material while lifting the material 5mm from the laser bed.

PLEASE NOTE, the gaps are 3.3mm and 6.6mm to allow for tolerance variation of 10% which can occur with material. The magnets are only intended to help keep the standoff in place and are not meant to hold bent or warped material level. If a stronger magnet is needed for such use one can be added to the bottom by you. You can easily glue a stronger magnet to the bottom to help hold your material straight and level. If you are using large material it is strongly encouraged to purchase more than 4 standoffs as the material can sag in the middle leading to poor cuts.